What it means
The controller has been in its main 'bulk' charging stage longer than its time limit allows. On solar chargers, Victron's advice is simply to update the firmware.
What you can check yourself
- Open VictronConnect and update the controller's firmware.
- Check the error clears after the update.
- If you also see the same code on a mains charger, note that it can point to a battery that can't reach full voltage.
Likely causes
- Older firmware on the solar charger
- On AC chargers, a battery with a shorted cell that never reaches absorption voltage
When to call a pro
If it continues after a firmware update, get your battery tested by an auto electrician.
Good to know about Victron SmartSolar / BlueSolar MPPT controllers
- Codes show in the VictronConnect app and on the controller's display if it has one.
- Many errors clear themselves once the condition goes away. A firmware update fixes a surprising number.
Understand the part
Other Victron codes
Err 1Battery temperature too highErr 2Battery voltage too highErr 17Controller overheated despite reduced output currentErr 18Controller over-currentErr 21Current sensor issueErr 26Terminal overheatedErr 28Power stage issueErr 33PV over-voltageErr 34PV over-currentErr 38 / Err 39PV input shutdownErr 67BMS connection lostErr 119Settings data lost
Checked against: Victron Energy documentation. Last reviewed October 2026. General guidance only, not a diagnosis.
