What it means
The battery voltage has gone higher than the controller considers safe, so it has stopped charging. It resets itself once the voltage drops.
What you can check yourself
- Check the battery voltage setting in the VictronConnect app matches your system (12V or 24V).
- Check the charge voltages match your battery type, especially if you've switched from lead-acid to lithium.
- Think about what else is charging at the same time (mains charger, B2B (battery-to-battery) charger, alternator) and switch those off one at a time to see if the error clears.
- Let the battery settle; the error should clear by itself once the voltage falls.
Likely causes
- Another charger (mains, B2B or alternator) pushing the voltage up
- Wrong battery voltage or battery type set in the controller
- A faulty charge controller
When to call a pro
If it keeps coming back with everything else switched off, ask an auto electrician to check the charging setup, because sustained overvoltage can damage batteries.
Good to know about Victron SmartSolar / BlueSolar MPPT controllers
- Codes show in the VictronConnect app and on the controller's display if it has one.
- Many errors clear themselves once the condition goes away. A firmware update fixes a surprising number.
Understand the part
Other Victron codes
Err 1Battery temperature too highErr 17Controller overheated despite reduced output currentErr 18Controller over-currentErr 20Maximum bulk time exceededErr 21Current sensor issueErr 26Terminal overheatedErr 28Power stage issueErr 33PV over-voltageErr 34PV over-currentErr 38 / Err 39PV input shutdownErr 67BMS connection lostErr 119Settings data lost
Checked against: Victron Energy documentation. Last reviewed October 2026. General guidance only, not a diagnosis.
