What it means
The control box has lost its signal from the flame sensor, which tells it whether the burner is alight. Without it the heater can't run safely.
What you can check yourself
- Switch off.
- Check visible connectors on the heater are secure.
- Try one restart. If 064 returns, book it in.
Likely causes
- Failed flame sensor
- Broken sensor wiring or connector
- Control box fault
When to call a pro
The flame sensor is inside the heater, so testing and replacing it is a specialist job.
Good to know about Eberspächer Airtronic diesel heaters
- These three-digit codes appear on EasyStart timers and diagnostic tools. The newer EasyStart Pro shows plain-text messages instead (for example 'Overheat. Heater locked.').
- Too many failed starts locks the heater out (050). It needs the fault memory cleared with a compatible controller or by a dealer.
Understand the part
Other Eberspächer codes
010Over-voltage cut-off011Under-voltage cut-off012Overheating015Operating lockout after overheating020Glow plug open circuit021Glow plug short circuit or overload031Blower motor open circuit048Fuel pump open circuit050Locked out — too many failed starts052No start — safety time exceeded053 (also 054, 055, 056)Flame went out while running060External temperature sensor open circuit
Checked against: Eberspächer troubleshooting manual (via UK distributor). Last reviewed October 2026. General guidance only, not a diagnosis.
