What it means
If you have a separate room temperature sensor fitted, the heater has lost its signal from it. The wire is broken or unplugged.
What you can check yourself
- Find the external temperature sensor (a small unit on a wire, usually on a cabinet or wall) and check it's plugged in.
- Check the wire along its route for damage.
- Reconnect and restart.
Likely causes
- Unplugged sensor
- Broken or chafed sensor wire
- Failed sensor
When to call a pro
If the sensor and wire look fine, a specialist can test its resistance.
Good to know about Eberspächer Airtronic diesel heaters
- These three-digit codes appear on EasyStart timers and diagnostic tools. The newer EasyStart Pro shows plain-text messages instead (for example 'Overheat. Heater locked.').
- Too many failed starts locks the heater out (050). It needs the fault memory cleared with a compatible controller or by a dealer.
Understand the part
Other Eberspächer codes
010Over-voltage cut-off011Under-voltage cut-off012Overheating015Operating lockout after overheating020Glow plug open circuit021Glow plug short circuit or overload031Blower motor open circuit048Fuel pump open circuit050Locked out — too many failed starts052No start — safety time exceeded053 (also 054, 055, 056)Flame went out while running064Flame sensor open circuit
Checked against: Eberspächer troubleshooting manual (via UK distributor). Last reviewed October 2026. General guidance only, not a diagnosis.
