What it means
The control box can't see the glow plug, the part that heats up to light the fuel. Either the plug has burnt out or its wiring is broken, so the heater can't ignite.
What you can check yourself
- Switch off.
- Check the battery is charged.
- If you can see the heater's wiring plugs, check they're seated.
- Try one restart. If 020 returns, book it in.
Likely causes
- Burnt-out glow plug
- Broken glow plug wiring or connector
When to call a pro
A specialist can measure the glow plug resistance and replace it, which normally means opening the heater.
Good to know about Eberspächer Airtronic diesel heaters
- These three-digit codes appear on EasyStart timers and diagnostic tools. The newer EasyStart Pro shows plain-text messages instead (for example 'Overheat. Heater locked.').
- Too many failed starts locks the heater out (050). It needs the fault memory cleared with a compatible controller or by a dealer.
Understand the part
Other Eberspächer codes
010Over-voltage cut-off011Under-voltage cut-off012Overheating015Operating lockout after overheating021Glow plug short circuit or overload031Blower motor open circuit048Fuel pump open circuit050Locked out — too many failed starts052No start — safety time exceeded053 (also 054, 055, 056)Flame went out while running060External temperature sensor open circuit064Flame sensor open circuit
Checked against: Eberspächer troubleshooting manual (via UK distributor). Last reviewed October 2026. General guidance only, not a diagnosis.
