What it means
The control box can't detect the blower (fan) motor. The wiring is broken or the motor has failed.
What you can check yourself
- Switch off.
- Check the heater's main plugs are secure.
- Make sure nothing is jammed in the air intake.
- Try one restart.
Likely causes
- Failed blower motor
- Broken motor wiring
- Control box fault
When to call a pro
A specialist can test the motor and wiring and replace parts as needed.
Good to know about Eberspächer Airtronic diesel heaters
- These three-digit codes appear on EasyStart timers and diagnostic tools. The newer EasyStart Pro shows plain-text messages instead (for example 'Overheat. Heater locked.').
- Too many failed starts locks the heater out (050). It needs the fault memory cleared with a compatible controller or by a dealer.
Understand the part
Other Eberspächer codes
010Over-voltage cut-off011Under-voltage cut-off012Overheating015Operating lockout after overheating020Glow plug open circuit021Glow plug short circuit or overload048Fuel pump open circuit050Locked out — too many failed starts052No start — safety time exceeded053 (also 054, 055, 056)Flame went out while running060External temperature sensor open circuit064Flame sensor open circuit
Checked against: Eberspächer troubleshooting manual (via UK distributor). Last reviewed October 2026. General guidance only, not a diagnosis.
