Stop using it until it's sorted. Restarting over and over can make things worse — and with heaters, a blocked flue or exhaust leak can let carbon monoxide into the van. Make sure your CO alarm works.
What it means
The overheating sensor detected the heater getting too hot. That's usually because warm air can't get out or cold air can't get in.
What you can check yourself
- Stop using the heater and let it cool.
- Check the hot-air pipes and outlet aren't blocked, crushed or kinked.
- Clear anything obstructing the air intake grille inside the van.
- Make sure outlet vents are open, then try once more.
Likely causes
- Blocked or crushed hot-air ducting
- Obstructed air intake
- Closed outlet vents
- Incorrect fuel quantity (needs a specialist to measure)
When to call a pro
If ducting is clear and it still overheats, a specialist should measure the fuel delivery and check the sensors.
Good to know about Eberspächer Airtronic diesel heaters
- These three-digit codes appear on EasyStart timers and diagnostic tools. The newer EasyStart Pro shows plain-text messages instead (for example 'Overheat. Heater locked.').
- Too many failed starts locks the heater out (050). It needs the fault memory cleared with a compatible controller or by a dealer.
Understand the part
Other Eberspächer codes
010Over-voltage cut-off011Under-voltage cut-off015Operating lockout after overheating020Glow plug open circuit021Glow plug short circuit or overload031Blower motor open circuit048Fuel pump open circuit050Locked out — too many failed starts052No start — safety time exceeded053 (also 054, 055, 056)Flame went out while running060External temperature sensor open circuit064Flame sensor open circuit
Checked against: Eberspächer troubleshooting manual (via UK distributor). Last reviewed October 2026. General guidance only, not a diagnosis.
