What it means
There's a break in the circuit to the fuel metering pump, the ticking pump usually mounted under the van. Without it no fuel reaches the heater.
What you can check yourself
- Switch off.
- Find the metering pump and check its plug is connected and free of corrosion.
- Trace the pump wiring for damage, especially near the chassis and exhaust.
- Try one restart.
Likely causes
- Disconnected or corroded pump plug
- Damaged pump wiring
- Failed metering pump
When to call a pro
If the plug and wiring look fine, have a specialist measure the pump and replace it.
Good to know about Eberspächer Airtronic diesel heaters
- These three-digit codes appear on EasyStart timers and diagnostic tools. The newer EasyStart Pro shows plain-text messages instead (for example 'Overheat. Heater locked.').
- Too many failed starts locks the heater out (050). It needs the fault memory cleared with a compatible controller or by a dealer.
Understand the part
Other Eberspächer codes
010Over-voltage cut-off011Under-voltage cut-off012Overheating015Operating lockout after overheating020Glow plug open circuit021Glow plug short circuit or overload031Blower motor open circuit050Locked out — too many failed starts052No start — safety time exceeded053 (also 054, 055, 056)Flame went out while running060External temperature sensor open circuit064Flame sensor open circuit
Checked against: Eberspächer troubleshooting manual (via UK distributor). Last reviewed October 2026. General guidance only, not a diagnosis.
