What it means
The heater tried to light but didn't detect a flame within the allowed time, so it stopped. It's the classic 'won't start' code, and it's usually fuel or blocked breathing.
What you can check yourself
- Check there's enough fuel in the tank, because the heater's pickup often stops short of empty.
- Check the exhaust outlet and air intake under the van are clear of mud, snow or debris and not crushed.
- Look for kinks or air bubbles in the fuel line.
- Try once more. Repeated attempts will lead to a lockout (050) and can leave unburnt fuel in the burner.
Likely causes
- Low fuel or air in the fuel line
- Blocked exhaust or combustion air intake
- Worn glow plug
- Faulty fuel pump or flame sensor
When to call a pro
If it still won't start with fuel and clear pipes, a specialist should check the glow plug, fuel delivery and flame sensor.
Good to know about Eberspächer Airtronic diesel heaters
- These three-digit codes appear on EasyStart timers and diagnostic tools. The newer EasyStart Pro shows plain-text messages instead (for example 'Overheat. Heater locked.').
- Too many failed starts locks the heater out (050). It needs the fault memory cleared with a compatible controller or by a dealer.
Understand the part
Other Eberspächer codes
010Over-voltage cut-off011Under-voltage cut-off012Overheating015Operating lockout after overheating020Glow plug open circuit021Glow plug short circuit or overload031Blower motor open circuit048Fuel pump open circuit050Locked out — too many failed starts053 (also 054, 055, 056)Flame went out while running060External temperature sensor open circuit064Flame sensor open circuit
Checked against: Eberspächer troubleshooting manual (via UK distributor). Last reviewed October 2026. General guidance only, not a diagnosis.
