What it means
The glow pin (the part that heats up to light the fuel) has an open or short circuit. With no working glow pin the heater can't ignite.
What you can check yourself
- Check the battery is well charged, because low voltage is hard on glow pins.
- Switch off and try one restart.
- If F09 returns, stop. The glow pin is inside the heater.
Likely causes
- Burnt-out glow pin
- Damaged glow pin wiring inside the heater
- Repeated low-voltage starts
When to call a pro
Replacing a glow pin means taking the heater apart, so it's a job for a Webasto specialist.
Good to know about Webasto Air Top diesel heaters
- The same F codes are used on the Air Top 2000 STC and the Air Top Evo 40 / 55.
- No display? The heater flashes the code instead: five quick flashes, then a number of slow flashes. Count the slow ones: that's the F number.
- Repeated failed starts or overheating will lock the heater out (F12). F13 is a permanent lockout that needs a Webasto dealer.
- MultiControl controllers show their own H codes, which aren't covered here.
Understand the part
Other Webasto codes
F00Control unit errorF01No start — heater didn't igniteF02Flame went out — repeatedlyF03Voltage too low or too highF04Flame detected too earlyF06Temperature sensor faultF07Fuel pump circuit faultF08Fan motor faultF10OverheatingF11Overheating sensor faultF12Heater locked out
Checked against: Manufacturer's manual (ManualsLib copy). Last reviewed October 2026. General guidance only, not a diagnosis.
