What it means
The heater 'saw' a flame before it should have, which shouldn't happen, so it stopped for safety. It can be a sensor or glow pin fault, or a combustion problem.
What you can check yourself
- Let the heater cool fully before trying again.
- Check the air intake and exhaust for blockages.
- Try one restart. If F04 returns, stop and book it in.
Likely causes
- Faulty flame sensor
- Faulty glow pin
- Combustion air or exhaust blockage
- Air in the fuel line
When to call a pro
A repeated F04 normally means a sensor or glow pin replacement, which is a job for a Webasto service agent.
Good to know about Webasto Air Top diesel heaters
- The same F codes are used on the Air Top 2000 STC and the Air Top Evo 40 / 55.
- No display? The heater flashes the code instead: five quick flashes, then a number of slow flashes. Count the slow ones: that's the F number.
- Repeated failed starts or overheating will lock the heater out (F12). F13 is a permanent lockout that needs a Webasto dealer.
- MultiControl controllers show their own H codes, which aren't covered here.
Understand the part
Other Webasto codes
F00Control unit errorF01No start — heater didn't igniteF02Flame went out — repeatedlyF03Voltage too low or too highF06Temperature sensor faultF07Fuel pump circuit faultF08Fan motor faultF09Glow pin faultF10OverheatingF11Overheating sensor faultF12Heater locked out
Checked against: Manufacturer's manual (ManualsLib copy). Last reviewed October 2026. General guidance only, not a diagnosis.
