What it means
The heater did light, but the flame went out more than three times, so it shut itself down. The causes are usually the same as F01: fuel supply or breathing problems.
What you can check yourself
- Check the fuel level and look for kinks, leaks or air bubbles in the fuel line.
- Check the exhaust and combustion air pipes are clear and not crushed.
- Look over the exhaust run for holes, loose clamps or black soot marks. An exhaust leak can let carbon monoxide (CO), a deadly gas you can't see or smell, into the van. If you suspect one, stop using the heater and make sure your CO alarm works.
- Switch off for at least 2 seconds and try once. Avoid repeated restarts, which can trigger a lockout.
Likely causes
- Fuel starvation (low tank, air in line, blocked filter)
- Restricted exhaust or air intake
- Fuel pump delivering unevenly
- Carbon build-up from short runs or low voltage
When to call a pro
If F02 keeps coming back, have a specialist check fuel delivery and look for carbon build-up, especially if you see smoke or smell fumes.
Good to know about Webasto Air Top diesel heaters
- The same F codes are used on the Air Top 2000 STC and the Air Top Evo 40 / 55.
- No display? The heater flashes the code instead: five quick flashes, then a number of slow flashes. Count the slow ones: that's the F number.
- Repeated failed starts or overheating will lock the heater out (F12). F13 is a permanent lockout that needs a Webasto dealer.
- MultiControl controllers show their own H codes, which aren't covered here.
Understand the part
Other Webasto codes
F00Control unit errorF01No start — heater didn't igniteF03Voltage too low or too highF04Flame detected too earlyF06Temperature sensor faultF07Fuel pump circuit faultF08Fan motor faultF09Glow pin faultF10OverheatingF11Overheating sensor faultF12Heater locked out
Checked against: Manufacturer's manual (ManualsLib copy). Last reviewed October 2026. General guidance only, not a diagnosis.
