What it means
The heater's brain (the control unit, sometimes called the ECU or electronic control unit) has spotted a problem with itself or its settings. On some controllers F00 can also show a lockout or a faulty built-in room temperature sensor.
What you can check yourself
- Switch the heater off and wait at least a couple of seconds before switching it back on.
- Check the leisure battery is charged and the heater fuse is sound.
- If F00 comes straight back, stop retrying and note when it happens (e.g. on start-up, mid-run).
Likely causes
- Internal control unit fault
- Incorrect parameter set in the control unit
- Faulty internal room temperature sensor
When to call a pro
If F00 keeps coming back after a restart, book it in with a Webasto service agent, because it usually needs diagnostic software.
Good to know about Webasto Air Top diesel heaters
- The same F codes are used on the Air Top 2000 STC and the Air Top Evo 40 / 55.
- No display? The heater flashes the code instead: five quick flashes, then a number of slow flashes. Count the slow ones: that's the F number.
- Repeated failed starts or overheating will lock the heater out (F12). F13 is a permanent lockout that needs a Webasto dealer.
- MultiControl controllers show their own H codes, which aren't covered here.
Understand the part
Other Webasto codes
F01No start — heater didn't igniteF02Flame went out — repeatedlyF03Voltage too low or too highF04Flame detected too earlyF06Temperature sensor faultF07Fuel pump circuit faultF08Fan motor faultF09Glow pin faultF10OverheatingF11Overheating sensor faultF12Heater locked out
Checked against: Manufacturer's manual (ManualsLib copy). Last reviewed October 2026. General guidance only, not a diagnosis.
