What it means
The heater has lost its signal from a temperature sensor (the wire is broken or shorted). On some setups it can also mean a missing resistor plug in the wiring loom.
What you can check yourself
- Check the external room temperature sensor, if fitted, is plugged in and its wire isn't damaged.
- Check the controller and main wiring plugs are pushed fully home.
- Switch off and on again after reseating connections.
Likely causes
- Unplugged or damaged temperature sensor
- Broken or chafed sensor wiring
- Missing 620-ohm resistor plug in the loom (some installs)
- Loose main harness connector
When to call a pro
If the connections look fine, a Webasto agent can test the sensor and loom.
Good to know about Webasto Air Top diesel heaters
- The same F codes are used on the Air Top 2000 STC and the Air Top Evo 40 / 55.
- No display? The heater flashes the code instead: five quick flashes, then a number of slow flashes. Count the slow ones: that's the F number.
- Repeated failed starts or overheating will lock the heater out (F12). F13 is a permanent lockout that needs a Webasto dealer.
- MultiControl controllers show their own H codes, which aren't covered here.
Understand the part
Other Webasto codes
F00Control unit errorF01No start — heater didn't igniteF02Flame went out — repeatedlyF03Voltage too low or too highF04Flame detected too earlyF07Fuel pump circuit faultF08Fan motor faultF09Glow pin faultF10OverheatingF11Overheating sensor faultF12Heater locked out
Checked against: Copy of the manufacturer's manual. Last reviewed October 2026. General guidance only, not a diagnosis.
