What it means
The supply voltage reaching the heater went outside its safe range, so it switched off. In campervans this is nearly always a tired leisure battery or thin, long or corroded wiring.
What you can check yourself
- Charge the leisure battery, or run the engine or plug into hook-up, then switch off for 2 seconds and restart.
- Check the heater fuse and fuse holder for corrosion or heat damage.
- Check the battery terminals are clean and tight.
- If you can, measure the voltage at the heater rather than at the battery. A big difference points to undersized or poor wiring.
Likely causes
- Flat or ageing leisure battery
- Voltage drop from undersized or long cables
- Corroded terminals, fuse holders or connectors
- Faulty charger or alternator regulation (over-voltage)
When to call a pro
If the battery is healthy and F03 continues, get an auto electrician to check the supply wiring and voltage drop under load.
Good to know about Webasto Air Top diesel heaters
- The same F codes are used on the Air Top 2000 STC and the Air Top Evo 40 / 55.
- No display? The heater flashes the code instead: five quick flashes, then a number of slow flashes. Count the slow ones: that's the F number.
- Repeated failed starts or overheating will lock the heater out (F12). F13 is a permanent lockout that needs a Webasto dealer.
- MultiControl controllers show their own H codes, which aren't covered here.
Understand the part
Other Webasto codes
F00Control unit errorF01No start — heater didn't igniteF02Flame went out — repeatedlyF04Flame detected too earlyF06Temperature sensor faultF07Fuel pump circuit faultF08Fan motor faultF09Glow pin faultF10OverheatingF11Overheating sensor faultF12Heater locked out
Checked against: Copy of the manufacturer's manual. Last reviewed October 2026. General guidance only, not a diagnosis.
