What it means
The sensor that watches for overheating has a broken or shorted connection, so the heater can't protect itself and won't run.
What you can check yourself
- Switch the heater off.
- Check visible wiring plugs at the heater are secure.
- Try one restart. If F11 returns, book it in.
Likely causes
- Faulty overheating sensor
- Damaged or loose sensor wiring
When to call a pro
The overheating sensor is inside the heater, so testing and replacing it is a specialist job.
Good to know about Webasto Air Top diesel heaters
- The same F codes are used on the Air Top 2000 STC and the Air Top Evo 40 / 55.
- No display? The heater flashes the code instead: five quick flashes, then a number of slow flashes. Count the slow ones: that's the F number.
- Repeated failed starts or overheating will lock the heater out (F12). F13 is a permanent lockout that needs a Webasto dealer.
- MultiControl controllers show their own H codes, which aren't covered here.
Understand the part
Other Webasto codes
F00Control unit errorF01No start — heater didn't igniteF02Flame went out — repeatedlyF03Voltage too low or too highF04Flame detected too earlyF06Temperature sensor faultF07Fuel pump circuit faultF08Fan motor faultF09Glow pin faultF10OverheatingF12Heater locked out
Checked against: Manufacturer's manual (ManualsLib copy). Last reviewed October 2026. General guidance only, not a diagnosis.
