What it means
The heater tried to start twice and couldn't get a flame going, so it has given up. It's the most common Webasto code, and it's nearly always about fuel or blocked air or exhaust.
What you can check yourself
- Check there's enough diesel in the tank. Many installs draw from a standpipe that stops short of the bottom, so the heater can run dry before the engine does.
- Look at the exhaust outlet and combustion air intake under the van and clear any mud, leaves, snow or crushed pipe.
- Switch off for at least 2 seconds and try once more. Don't keep hammering the button, because repeated failed starts lead to a lockout (F12) and can leave unburnt fuel in the burner.
- If the tank has run low or been refilled, the fuel line may need bleeding before it'll fire.
Likely causes
- Low fuel or air in the fuel line
- Blocked or crushed exhaust or combustion air pipe
- Faulty fuel metering pump
- Worn or failing glow pin
When to call a pro
If it still won't start with fuel in the tank and clear pipes, get a Webasto specialist to check the pump, fuel delivery and glow pin.
Good to know about Webasto Air Top diesel heaters
- The same F codes are used on the Air Top 2000 STC and the Air Top Evo 40 / 55.
- No display? The heater flashes the code instead: five quick flashes, then a number of slow flashes. Count the slow ones: that's the F number.
- Repeated failed starts or overheating will lock the heater out (F12). F13 is a permanent lockout that needs a Webasto dealer.
- MultiControl controllers show their own H codes, which aren't covered here.
Understand the part
Other Webasto codes
F00Control unit errorF02Flame went out — repeatedlyF03Voltage too low or too highF04Flame detected too earlyF06Temperature sensor faultF07Fuel pump circuit faultF08Fan motor faultF09Glow pin faultF10OverheatingF11Overheating sensor faultF12Heater locked out
Checked against: Copy of the manufacturer's manual. Last reviewed October 2026. General guidance only, not a diagnosis.
