What it means
The fridge is set to 12V but isn't getting a 12V supply. On most motorhomes, 12V mode only works with the engine running.
What you can check yourself
- Check the engine or ignition is on.
- Check the vehicle fuse for the fridge.
- Check the vehicle battery is charged.
- Select gas or mains when parked.
Likely causes
- Ignition off
- Blown vehicle fuse
- Flat vehicle battery
When to call a pro
If the engine's running and the fuses are fine, an auto electrician should check the fridge's 12V and D+ feed.
Good to know about Dometic absorption (3-way) fridges
- Newer RMD 10.5 fridges show W (warning) and E (error) codes. Older RM 8 fridges with AES or MES control flash a red failure light alongside the mode that has a problem.
- Absorption fridges need to be roughly level to cool properly. If it's not cooling, check that first.
Understand the part
Other Dometic codes
E07 / E08 / E09No cooling in gas / mains / 12V modeE14Low battery in stand-alone gas modeE50Gas lockout after 3 ignition attemptsFailure LED + 12 flashingNo 12V or voltage under 10.5VFailure LED + 230 flashingNo mains or voltage under 195VFailure LED + GAS flashingGas ignition failedFailure LED + temperature LEDs flashingTemperature sensor (NTC) faultTank StopGas mode blocked for 15 minutesW01Temperature sensor faultW05No mains power or mains too lowW10Door open more than 2 minutesW1112V overvoltage (over 16V)
Checked against: Dometic manual. Last reviewed October 2026. General guidance only, not a diagnosis.
