What it means
The fridge is set to mains but there's no 230V supply, or it's below 190V.
What you can check yourself
- Check your hook-up is plugged in and the bollard hasn't tripped.
- Check the van's RCD and breakers.
- Check the fridge's mains switch or fuse if it has one.
- Select gas meanwhile.
Likely causes
- Not connected to hook-up
- Weak campsite supply
- Tripped breaker or blown fuse
When to call a pro
If mains is definitely fine, a habitation engineer should check the fridge's 230V supply and element.
Good to know about Dometic absorption (3-way) fridges
- Newer RMD 10.5 fridges show W (warning) and E (error) codes. Older RM 8 fridges with AES or MES control flash a red failure light alongside the mode that has a problem.
- Absorption fridges need to be roughly level to cool properly. If it's not cooling, check that first.
Understand the part
Other Dometic codes
E07 / E08 / E09No cooling in gas / mains / 12V modeE14Low battery in stand-alone gas modeE50Gas lockout after 3 ignition attemptsFailure LED + 12 flashingNo 12V or voltage under 10.5VFailure LED + 230 flashingNo mains or voltage under 195VFailure LED + GAS flashingGas ignition failedFailure LED + temperature LEDs flashingTemperature sensor (NTC) faultTank StopGas mode blocked for 15 minutesW01Temperature sensor faultW06No 12V powerW10Door open more than 2 minutesW1112V overvoltage (over 16V)
Checked against: Dometic manual. Last reviewed October 2026. General guidance only, not a diagnosis.
