What it means
The fridge has run on gas (E07), mains (E08) or 12V (E09) but isn't producing any cooling. Absorption fridges are fussy about being level.
What you can check yourself
- Check the van is level. Use a spirit level on the fridge floor and use levelling ramps.
- Reset the error by pressing the power button for 2 seconds (TFT display) or the MODE button for 2 seconds (LED panel).
- Check the outside fridge vents aren't blocked.
- Give it a few hours to cool from warm.
Likely causes
- Van parked off-level
- Blocked ventilation
- A cooling unit fault
When to call a pro
If it won't cool when level and ventilated, a habitation engineer should check the cooling unit.
Good to know about Dometic absorption (3-way) fridges
- Newer RMD 10.5 fridges show W (warning) and E (error) codes. Older RM 8 fridges with AES or MES control flash a red failure light alongside the mode that has a problem.
- Absorption fridges need to be roughly level to cool properly. If it's not cooling, check that first.
Understand the part
Other Dometic codes
E14Low battery in stand-alone gas modeE50Gas lockout after 3 ignition attemptsFailure LED + 12 flashingNo 12V or voltage under 10.5VFailure LED + 230 flashingNo mains or voltage under 195VFailure LED + GAS flashingGas ignition failedFailure LED + temperature LEDs flashingTemperature sensor (NTC) faultTank StopGas mode blocked for 15 minutesW01Temperature sensor faultW05No mains power or mains too lowW06No 12V powerW10Door open more than 2 minutesW1112V overvoltage (over 16V)
Checked against: Dometic manual. Last reviewed October 2026. General guidance only, not a diagnosis.
