What it means
The fridge wants 12V but either isn't getting it or it's below 10.5V.
What you can check yourself
- Check the engine is running (the D+ signal).
- Check the fridge's 12V fuse.
- Check the vehicle battery.
- Select gas or mains when parked.
Likely causes
- Engine off
- Blown fuse
- Low battery or poor wiring
When to call a pro
If the engine's running and the fuse is fine, an auto electrician should check the 12V and D+ supply.
Good to know about Dometic absorption (3-way) fridges
- Newer RMD 10.5 fridges show W (warning) and E (error) codes. Older RM 8 fridges with AES or MES control flash a red failure light alongside the mode that has a problem.
- Absorption fridges need to be roughly level to cool properly. If it's not cooling, check that first.
Understand the part
Other Dometic codes
E07 / E08 / E09No cooling in gas / mains / 12V modeE14Low battery in stand-alone gas modeE50Gas lockout after 3 ignition attemptsFailure LED + 230 flashingNo mains or voltage under 195VFailure LED + GAS flashingGas ignition failedFailure LED + temperature LEDs flashingTemperature sensor (NTC) faultTank StopGas mode blocked for 15 minutesW01Temperature sensor faultW05No mains power or mains too lowW06No 12V powerW10Door open more than 2 minutesW1112V overvoltage (over 16V)
Checked against: Copy of the manufacturer's manual. Last reviewed October 2026. General guidance only, not a diagnosis.
