What it means
The temperature sensor in the fridge compartment is faulty. It's a warning, so it can clear itself if the sensor recovers.
What you can check yourself
- Keep an eye on food temperature with a thermometer.
- Switch off and on to see whether it clears.
- Avoid overfilling the fridge while it's like this.
Likely causes
- Faulty or disconnected compartment temperature sensor
When to call a pro
Dometic says to contact an authorised service centre, which can be a habitation engineer approved for Dometic.
Good to know about Dometic absorption (3-way) fridges
- Newer RMD 10.5 fridges show W (warning) and E (error) codes. Older RM 8 fridges with AES or MES control flash a red failure light alongside the mode that has a problem.
- Absorption fridges need to be roughly level to cool properly. If it's not cooling, check that first.
Understand the part
Other Dometic codes
E07 / E08 / E09No cooling in gas / mains / 12V modeE14Low battery in stand-alone gas modeE50Gas lockout after 3 ignition attemptsFailure LED + 12 flashingNo 12V or voltage under 10.5VFailure LED + 230 flashingNo mains or voltage under 195VFailure LED + GAS flashingGas ignition failedFailure LED + temperature LEDs flashingTemperature sensor (NTC) faultTank StopGas mode blocked for 15 minutesW05No mains power or mains too lowW06No 12V powerW10Door open more than 2 minutesW1112V overvoltage (over 16V)
Checked against: Dometic manual. Last reviewed October 2026. General guidance only, not a diagnosis.
