What it means
In stand-alone gas mode, the fridge uses its own small batteries to keep the gas control running, and they're getting low.
What you can check yourself
- Fit new batteries in the fridge's battery holder, as shown in the manual.
- Reset the error (power button 2 seconds on TFT, MODE button 2 seconds on LED).
Likely causes
- Flat stand-alone batteries
When to call a pro
No engineer needed unless the code returns with fresh batteries.
Good to know about Dometic absorption (3-way) fridges
- Newer RMD 10.5 fridges show W (warning) and E (error) codes. Older RM 8 fridges with AES or MES control flash a red failure light alongside the mode that has a problem.
- Absorption fridges need to be roughly level to cool properly. If it's not cooling, check that first.
Understand the part
Other Dometic codes
E07 / E08 / E09No cooling in gas / mains / 12V modeE50Gas lockout after 3 ignition attemptsFailure LED + 12 flashingNo 12V or voltage under 10.5VFailure LED + 230 flashingNo mains or voltage under 195VFailure LED + GAS flashingGas ignition failedFailure LED + temperature LEDs flashingTemperature sensor (NTC) faultTank StopGas mode blocked for 15 minutesW01Temperature sensor faultW05No mains power or mains too lowW06No 12V powerW10Door open more than 2 minutesW1112V overvoltage (over 16V)
Checked against: Dometic manual. Last reviewed October 2026. General guidance only, not a diagnosis.
