What it means
The 230V heating element is drawing much less current than it should, which Thetford says indicates a defective 230V element.
What you can check yourself
- Check your hook-up is live and other 230V sockets work.
- Switch the fridge off and on.
- Use gas or 12V (when driving) in the meantime.
Likely causes
- Faulty 230V heating element
- Low mains voltage
- Blown fridge mains fuse
When to call a pro
Get a habitation engineer to test and replace the element. Don't open the fridge's mains electrics yourself.
Good to know about Thetford N3000 / N4000 fridges
- N3000 and N4000 fridges share the same error numbers. Older N3000 panels show the code as a pattern of lights rather than a number.
- On the N4000, hold all three buttons together until the flashing stops to see the code.
Understand the part
Other Thetford codes
All lights blinkingSeveral errors at onceError 3Gas lockout: flame didn't light within 30 secondsError 412V heater not workingError 612V supply out of rangeError 7D+ (engine running) signal missingError 10230V supply out of rangeError 11No energy source availableError 12Display and power board lost communicationError 13Temperature sensor fault: running in backup mode
Checked against: Thetford manual. Last reviewed October 2026. General guidance only, not a diagnosis.
