What it means
The fridge is set to 12V but isn't getting the 'D+' signal that tells it the engine is running. 12V mode on these fridges only works while driving.
What you can check yourself
- Check the engine is actually running.
- If you're parked, switch to gas or 230V instead.
- If the engine is running and you still get the code, check the fridge fuses.
Likely causes
- Engine not running
- Faulty D+ wiring or relay
- Wiring polarity problem
When to call a pro
If the engine's running and it still shows, an auto electrician should check the D+ signal wiring.
Good to know about Thetford N3000 / N4000 fridges
- N3000 and N4000 fridges share the same error numbers. Older N3000 panels show the code as a pattern of lights rather than a number.
- On the N4000, hold all three buttons together until the flashing stops to see the code.
Understand the part
Other Thetford codes
All lights blinkingSeveral errors at onceError 3Gas lockout: flame didn't light within 30 secondsError 412V heater not workingError 612V supply out of rangeError 8230V heater faultError 10230V supply out of rangeError 11No energy source availableError 12Display and power board lost communicationError 13Temperature sensor fault: running in backup mode
Checked against: Thetford manual. Last reviewed October 2026. General guidance only, not a diagnosis.
