What it means
The 12V heating element isn't on when it should be. Thetford says this usually means a faulty 12V element, though a fuse or connection can cause it.
What you can check yourself
- Switch the fridge off and on again.
- Check the fridge's 12V fuse in your van's fuse box.
- Use gas or 230V instead while travelling.
Likely causes
- Faulty 12V heating element
- Blown fuse (Thetford's guide mentions a 25A fuse)
- Loose connection
When to call a pro
If the fuse is fine and the code stays, a habitation engineer will need to test or replace the element.
Good to know about Thetford N3000 / N4000 fridges
- N3000 and N4000 fridges share the same error numbers. Older N3000 panels show the code as a pattern of lights rather than a number.
- On the N4000, hold all three buttons together until the flashing stops to see the code.
Understand the part
Other Thetford codes
All lights blinkingSeveral errors at onceError 3Gas lockout: flame didn't light within 30 secondsError 612V supply out of rangeError 7D+ (engine running) signal missingError 8230V heater faultError 10230V supply out of rangeError 11No energy source availableError 12Display and power board lost communicationError 13Temperature sensor fault: running in backup mode
Checked against: Thetford manual. Last reviewed October 2026. General guidance only, not a diagnosis.
