What it means
When every light on the panel blinks, the fridge has logged more than one fault at the same time.
What you can check yourself
- Switch the fridge off and on again.
- Check all your power sources (gas on, hook-up live, battery charged).
- On the N4000, Thetford says to hold all three control buttons together until the flashing stops to read the code, then look it up.
Likely causes
- Multiple simultaneous faults, such as no gas and no 12V
- A control board issue
When to call a pro
If the lights keep blinking after a reset, contact a Thetford service centre or habitation engineer.
Good to know about Thetford N3000 / N4000 fridges
- N3000 and N4000 fridges share the same error numbers. Older N3000 panels show the code as a pattern of lights rather than a number.
- On the N4000, hold all three buttons together until the flashing stops to see the code.
Understand the part
Other Thetford codes
Error 3Gas lockout: flame didn't light within 30 secondsError 412V heater not workingError 612V supply out of rangeError 7D+ (engine running) signal missingError 8230V heater faultError 10230V supply out of rangeError 11No energy source availableError 12Display and power board lost communicationError 13Temperature sensor fault: running in backup mode
Checked against: Thetford manual. Last reviewed October 2026. General guidance only, not a diagnosis.
