What it means
The mains supply is outside the range the fridge accepts (190–260V). This is common on weak campsite hook-ups.
What you can check yourself
- Check your hook-up lead is fully plugged in at both ends and the bollard trip hasn't gone.
- Check your van's RCD (residual current device) and MCBs (miniature circuit breakers) haven't tripped.
- Ask the site whether the supply is low, which is common at busy times.
- Switch to gas meanwhile.
Likely causes
- Weak or overloaded campsite supply
- A long or damaged hook-up cable
- Tripped breaker
When to call a pro
If the supply is fine and the code persists, get a habitation engineer to look at the fridge.
Good to know about Thetford N3000 / N4000 fridges
- N3000 and N4000 fridges share the same error numbers. Older N3000 panels show the code as a pattern of lights rather than a number.
- On the N4000, hold all three buttons together until the flashing stops to see the code.
Understand the part
Other Thetford codes
All lights blinkingSeveral errors at onceError 3Gas lockout: flame didn't light within 30 secondsError 412V heater not workingError 612V supply out of rangeError 7D+ (engine running) signal missingError 8230V heater faultError 11No energy source availableError 12Display and power board lost communicationError 13Temperature sensor fault: running in backup mode
Checked against: Thetford manual. Last reviewed October 2026. General guidance only, not a diagnosis.
