What it means
The control panel and the fridge's main power board at the back have stopped talking to each other.
What you can check yourself
- Switch the fridge off and on again.
- Check your 12V supply is healthy.
- Thetford's guide suggests disconnecting the 12V supply, waiting 5 minutes and reconnecting. Turning off the fridge fuse or the leisure battery isolator does this.
Likely causes
- Low or unstable 12V supply
- Loose cable between the boards
- Failed display or power board
When to call a pro
If it comes back after a reset, a habitation engineer will need to check the connecting cable and boards.
Good to know about Thetford N3000 / N4000 fridges
- N3000 and N4000 fridges share the same error numbers. Older N3000 panels show the code as a pattern of lights rather than a number.
- On the N4000, hold all three buttons together until the flashing stops to see the code.
Understand the part
Other Thetford codes
All lights blinkingSeveral errors at onceError 3Gas lockout: flame didn't light within 30 secondsError 412V heater not workingError 612V supply out of rangeError 7D+ (engine running) signal missingError 8230V heater faultError 10230V supply out of rangeError 11No energy source availableError 13Temperature sensor fault: running in backup mode
Checked against: Thetford manual. Last reviewed October 2026. General guidance only, not a diagnosis.
