What it means
A switch on the window near the boiler's wall flue has detected it's open, so gas heating pauses. Electric heating carries on.
What you can check yourself
- Close the window nearest the boiler's outside flue.
- Make sure it's fully latched.
- Gas heating resumes by itself.
Likely causes
- Window near the flue open
- Window not fully shut
When to call a pro
If the window is closed and the message stays, ask a habitation engineer to check the window switch.
Good to know about Alde Compact wet heating boilers
- Alde panels show text messages rather than numbered codes.
- Most faults reset by switching the boiler's 12V supply off and back on, usually at the habitation master switch. Never open the boiler to do it.
Understand the part
Other Alde codes
Connection failurePanel can't talk to the boilerFan failureCombustion fan faultGas failureBoiler couldn't light the gasLow battery voltageBattery too low – boiler stoppedOverheat PCBBoiler electronics overheatedOverheat glycolHeating fluid overheatedOverheat red failOverheat protection tripped (red sensor)
Checked against: Alde operating instructions. Last reviewed October 2026. General guidance only, not a diagnosis.
