Stop using it until it's sorted. Restarting over and over can make things worse — and with heaters, a blocked flue or exhaust leak can let carbon monoxide into the van. Make sure your CO alarm works.
What it means
The fan that feeds air to the gas burner isn't reaching the right speed, so the boiler can't burn gas safely. 'Fan restarts…' on its own is just a retry and needs no action, but 'Fan failure' means the retries have failed.
What you can check yourself
- Don't keep using gas heating – switch to electric if you have hook-up.
- Try one reset by turning the boiler's 12-volt supply off and back on.
- Check the outside flue for blockages such as snow, ice or leaves.
Likely causes
- Faulty combustion fan
- Blocked flue
- Low voltage to the fan
When to call a pro
Alde says to contact an Alde service partner for a fan failure.
Good to know about Alde Compact wet heating boilers
- Alde panels show text messages rather than numbered codes.
- Most faults reset by switching the boiler's 12V supply off and back on, usually at the habitation master switch. Never open the boiler to do it.
Understand the part
Other Alde codes
Connection failurePanel can't talk to the boilerGas failureBoiler couldn't light the gasLow battery voltageBattery too low – boiler stoppedOverheat PCBBoiler electronics overheatedOverheat glycolHeating fluid overheatedOverheat red failOverheat protection tripped (red sensor)Window openWindow open near the flue
Checked against: Alde operating instructions. Last reviewed October 2026. General guidance only, not a diagnosis.
