What it means
On the 3010 and 3020, one of the boiler's overheat cut-outs (the one on the red cable) has tripped. Alde points to air in the system or low fluid as the usual reasons.
What you can check yourself
- Switch off and let the boiler cool.
- Check the expansion tank: when cold, the fluid should be at least 1 cm above minimum.
- Bleed air from the heating system as your handbook shows.
- Reset by turning the 12-volt supply to the boiler off and on.
Likely causes
- Air in the heating system
- Low fluid level
- Circulation pump problem
When to call a pro
If it trips again after bleeding and topping up, contact your dealer or an Alde service partner.
Good to know about Alde Compact wet heating boilers
- Alde panels show text messages rather than numbered codes.
- Most faults reset by switching the boiler's 12V supply off and back on, usually at the habitation master switch. Never open the boiler to do it.
Understand the part
Other Alde codes
Connection failurePanel can't talk to the boilerFan failureCombustion fan faultGas failureBoiler couldn't light the gasLow battery voltageBattery too low – boiler stoppedOverheat PCBBoiler electronics overheatedOverheat glycolHeating fluid overheatedWindow openWindow open near the flue
Checked against: Manufacturer's manual (ManualsLib copy). Last reviewed October 2026. General guidance only, not a diagnosis.
