What it means
There's a fault in the connection between the boiler and the control panel. On the 3030 it reads 'Connector failure', and Alde points to the red cable and its red connectors.
What you can check yourself
- Check the habitation 12-volt supply is on and the battery is charged.
- Reset by turning the 12-volt supply off and back on.
- If that doesn't work, Alde suggests disconnecting the mains (230-volt) hook-up as well, then reconnecting both.
Likely causes
- Loose or damaged cable between the panel and the boiler
- Power interruption
- Circuit board fault ('Heater not found')
When to call a pro
If it won't clear after a full power reset, contact your dealer or an Alde service partner.
Good to know about Alde Compact wet heating boilers
- Alde panels show text messages rather than numbered codes.
- Most faults reset by switching the boiler's 12V supply off and back on, usually at the habitation master switch. Never open the boiler to do it.
Understand the part
Other Alde codes
Fan failureCombustion fan faultGas failureBoiler couldn't light the gasLow battery voltageBattery too low – boiler stoppedOverheat PCBBoiler electronics overheatedOverheat glycolHeating fluid overheatedOverheat red failOverheat protection tripped (red sensor)Window openWindow open near the flue
Checked against: Copy of the manufacturer's manual. Last reviewed October 2026. General guidance only, not a diagnosis.
