What it means
The temperature sensor the electronic unit uses (an NTC thermistor, a temperature-sensitive resistor) is shorted or disconnected, so the unit can't control the temperature. This only applies to fridges that use the Secop electronic thermostat input.
What you can check yourself
- Switch off.
- Check any visible thermostat or sensor plugs are seated.
- Switch back on.
Likely causes
- Disconnected thermostat sensor
- Damaged sensor wire
- Failed sensor
When to call a pro
If reseating doesn't fix it, a fridge engineer can test or replace the sensor.
Good to know about 12V compressor fridges (Secop / Danfoss BD35F & BD50F)
- Most 12V compressor fridges in campervans (many Dometic, Vitrifrigo and Isotherm models) use a Secop BD35F or BD50F compressor. If a diagnostic LED is fitted, it flashes these codes. The sequence repeats every four seconds.
- Fridges with their own digital display may show the manufacturer's own codes instead.
Understand the part
Other Secop (formerly Danfoss) codes
1 flashBattery protection cut-out2 flashesToo many starts or fan over-current3 flashesCompressor motor start error4 flashesMinimum motor speed error5 flashesElectronic unit overheated
Checked against: Secop electronic unit instructions. Last reviewed October 2026. General guidance only, not a diagnosis.
