What it means
Either the compressor or fan has tried to start too many times in a short period, or the cooling fan is drawing too much current (over 0.5 amps on average).
What you can check yourself
- Switch the fridge off for a few minutes, then back on. Don't flick it on and off repeatedly.
- Check the condenser fan (usually at the back or base of the fridge) spins freely and isn't clogged with dust or fluff.
- Make sure the fridge vents aren't blocked.
Likely causes
- Rapid on-off switching
- Fan jammed, clogged or failing
- Unstable supply voltage causing repeated restarts
When to call a pro
If the fan is clear and it keeps flashing twice, a fridge or refrigeration engineer can test the fan and electronic unit.
Good to know about 12V compressor fridges (Secop / Danfoss BD35F & BD50F)
- Most 12V compressor fridges in campervans (many Dometic, Vitrifrigo and Isotherm models) use a Secop BD35F or BD50F compressor. If a diagnostic LED is fitted, it flashes these codes. The sequence repeats every four seconds.
- Fridges with their own digital display may show the manufacturer's own codes instead.
Understand the part
Other Secop (formerly Danfoss) codes
1 flashBattery protection cut-out3 flashesCompressor motor start error4 flashesMinimum motor speed error5 flashesElectronic unit overheated6 flashesThermostat sensor fault
Checked against: Secop electronic unit instructions. Last reviewed October 2026. General guidance only, not a diagnosis.
