What it means
Usually means the controller and the heater have stopped talking to each other, often because of a loose plug in the controller cable. Codes vary by model and seller, so check your own heater's manual.
What you can check yourself
- Unplug and firmly reconnect the controller cable at both ends.
- Check the cable for damage or pinching along its route.
- Check the supply voltage is healthy.
Likely causes
- Loose controller plug
- Damaged controller cable
- Low voltage
When to call a pro
If reseating the cable doesn't fix it, the controller or control board may need replacing.
Good to know about Budget 'Chinese' diesel heaters (LCD controller)
- These codes vary between models and sellers. What's here is the most common meaning across the popular LCD controllers. If your manual says something different, trust the manual.
- These heaters are often self-fitted. A badly routed exhaust can leak carbon monoxide into the van, so always run a working CO alarm.
Understand the part
Other Generic (Chinese) codes
E-01Voltage too lowE-02Voltage too highE-03Glow plug faultE-04Fuel pump faultE-05OverheatingE-06Fan motor faultE-08Flame out / failed to startE-10Ignition failure after repeated attempts
Checked against: Diesel Heaters NI troubleshooting guide — codes for this product vary between models, so check your own manual too. Last reviewed October 2026. General guidance only, not a diagnosis.
