What it means
Usually means a problem with the glow plug or its circuit, so the heater can't light the fuel. Codes vary by model and seller, so check your own heater's manual.
What you can check yourself
- Check the battery voltage first, because low voltage can trigger this.
- With power off, check the glow plug connector inside the heater is clean and secure.
- Replacement glow plugs are cheap and widely available. Only fit one yourself if you're confident, with the power disconnected.
Likely causes
- Burnt-out glow plug
- Loose or corroded glow plug connection
- Low supply voltage
When to call a pro
If you're not comfortable opening the heater, a diesel heater specialist or auto electrician can test and replace the glow plug.
Good to know about Budget 'Chinese' diesel heaters (LCD controller)
- These codes vary between models and sellers. What's here is the most common meaning across the popular LCD controllers. If your manual says something different, trust the manual.
- These heaters are often self-fitted. A badly routed exhaust can leak carbon monoxide into the van, so always run a working CO alarm.
Understand the part
Other Generic (Chinese) codes
E-01Voltage too lowE-02Voltage too highE-04Fuel pump faultE-05OverheatingE-06Fan motor faultE-07Controller communication faultE-08Flame out / failed to startE-10Ignition failure after repeated attempts
Checked against: Diesel Heaters NI troubleshooting guide — codes for this product vary between models, so check your own manual too. Last reviewed October 2026. General guidance only, not a diagnosis.
