What it means
The control panel can't talk to the heater. Usually the heater isn't getting 12-volt power, or the cable between the panel and the heater has come loose or failed. It often shows briefly when you first switch on, while the system wakes up.
What you can check yourself
- Give it a minute after switching on – if the code clears by itself, it was just the system starting up.
- Check the habitation 12-volt master switch is on and your leisure battery is charged.
- Check the fuse for the heater on your van's fuse board or power unit (your handbook shows which one) and replace it with the same rating if it has blown.
- Turn the 12-volt supply off, wait 30 seconds, turn it back on, then acknowledge the code by pressing the knob.
- If you have solar or a mains charger fitted, Truma suggests briefly unplugging them to rule out a noisy power supply, then try again.
Likely causes
- 12-volt supply switched off or leisure battery flat
- Blown fuse feeding the heater
- Loose, damaged or unplugged panel cable
- Fault with the power supply unit or charger
When to call a pro
If the 12-volt supply is definitely fine and the code won't clear, book a Truma service agent or habitation engineer to check the panel cable and the heater's electronics.
Good to know about Truma Combi heaters (gas, E and D)
- W means a warning: the heater carries on as best it can and the warning clears itself once things are back in range. E means a fault: the heater stops. The H on the end just means 'heater'.
- On a CP plus panel, turn the knob to the warning triangle and press it to read the code. Fix the cause, then press the knob again to clear it.
- Reset more than four times in 15 minutes and the heater blocks itself for 15 minutes (E 607 H). Stop, find the cause, then try once.
- There are two generations of codes. Older Combis show two- or three-digit codes (E 112 H, W 24 H); newer ones show 400-600 series codes (E 517 H, W 401 H). Some numbers are described slightly differently between the two, so treat the meaning as a strong pointer rather than gospel.
Understand the part
Other Truma codes
E 43 HVoltage too highE 44 HBattery too low – heater has stoppedE 112 HFlame not detected – usually no gas reaching the heaterE 121 HGas valve closed or flame unstableE 122 HFlue or air intake blocked (older gas heaters)E 202 HGas not getting through – flame failureE 211 HGas valve closed or flame unstableE 212 HFlue or air intake blocked (or no gas)E 507 HGas supply interrupted while runningE 517 HGas supply interrupted – heater has locked outE 607 HToo many resets – heater blocked for 15 minutesE 621 HRoom temperature sensor faultE 632 HElectric overheat protection trippedW 17 HHot water mode with an empty water heaterW 18 HWarm air can't get out – heater overheatingW 24 HBattery getting low – heater may stop soonW 42 HWindow open above the flueW 45 HNo mains (230-volt) power to the heaterW 401 HHot water mode with an empty water heater (newer heaters)W 402 HAir overheating (newer heaters)W 408 HGas dropped out in mixed (gas plus electric) modeE 122 HDiesel heater out of fuelE 131 HDiesel heater lost contact with the panel
Checked against: Copy of the manufacturer's manual. Last reviewed October 2026. General guidance only, not a diagnosis.
