What it means
Pressing the flush does nothing. On these models you press once to wake the panel, then hold the button for a few seconds to flush.
What you can check yourself
- Press once to activate, then hold the flush button for several seconds.
- Check there's water in the flush tank (C262 separate tank) or in the van's fresh tank (CW versions).
- Check the van's 12V is on and the leisure battery isn't flat.
- Listen for the pump. The toilet has a self-resetting fuse, so wait a few minutes and try again.
Likely causes
- No water
- No 12V power
- Self-resetting fuse tripped
- Faulty pump, valve or control panel
When to call a pro
If there's water and 12V but no pump, a habitation engineer can replace the pump or control panel.
Good to know about Thetford cassette toilets
- The fill indicator works off a float with a magnet inside the cassette. Most 'faults' are a float stuck with paper or a cassette not pushed fully home.
Understand the part
Other Thetford codes
Lower / middle / top LEDThree-level fill indicatorNo level lightLevel indicator not workingRed light flashingCassette missing or not seated properlyRed light onCassette nearly full
Checked against: Thetford manual. Last reviewed October 2026. General guidance only, not a diagnosis.
